How to Read Repeat Signs in Drum Sheet Music — Repeat Bars, 1st and 2nd Endings, D.C., D.S., Coda and Fine
Repeat signs in drum sheet music are road signs that tell you where to jump back and play again. A repeat bar (‖: :‖) means play that section once more, D.C. (da capo) means go back to the beginning, D.S. (dal segno) means go back to the segno sign (𝄋), the coda sign (𝄌) means “skip ahead to the ending here,” and Fine means “stop here.”
Each sign is simple on its own, but real charts mix them, and it is easy to lose your place. After a table of the signs, this guide walks through four examples that turn the order written on the page into the order you actually play. The basic shapes of the bar repeat, repeat bars and 1st/2nd endings are also covered in the “use repeat signs” part of How to Write Drum Notation — 5 Steps to Writing Drum Sheet Music by Hand (Staff Positions, Stems, Repeat Signs, With Audio).
- Repeat bars = play the section again / 1st and 2nd endings = change only the last bar the second time.
- D.C. = back to the start, D.S. = back to the segno (𝄋). “al Fine” means stop at Fine; “al Coda” means jump to the coda at “To Coda.”
- After a D.C. or D.S., repeats are usually not taken again (unless the chart says so).
- Drum charts use lots of bar-repeat signs with small numbers (4, 8) above them — count bars as you play.
- Pencil the playing order in before you start and you will not get lost.
Drum Sheet Music Repeat Signs at a Glance
| Sign | What it looks like | What it means |
|---|---|---|
| Repeat bars | ‖: … :‖ (thick double bar line with two dots) | Play the section between them again. With no opening ‖:, go back to the very start. |
| 1st and 2nd endings | Brackets over the bars: [1. [2. | Play the 1st-ending bar the first time; on the repeat, skip it and play the 2nd ending. |
| Bar repeat | One slash with two dots (looks like %) | Play the previous bar again. A two-slash version repeats the previous two bars. |
| Repeat count | ×4, 4x | Play that bar (or section) that many times. |
| D.C. (Da Capo) | Text | Go back to the very beginning. |
| D.S. (Dal Segno) | Text | Go back to the segno sign (𝄋). |
| Segno | 𝄋 (an S with a slash and dots) | Where D.S. sends you back to. |
| To Coda / Coda | 𝄌 (a circle with a cross) | After jumping back, when you reach To Coda, skip to the bar marked with the coda sign. |
| Fine | Text | After jumping back, the song ends here. |
D.C. and D.S. usually say where to finish: D.C. al Fine = back to the start, stop at Fine; D.S. al Fine = back to the segno, stop at Fine; D.C. al Coda and D.S. al Coda = jump back, then skip to the coda at To Coda.
Example 1 — Repeat Bars With 1st and 2nd Endings
The chart is written with bar numbers. The 1st ending is bar 4; the 2nd ending is bar 5.
Chart: |: 1 | 2 | 3 |[1. 4 :|[2. 5 || Play order: 1 → 2 → 3 → 4 → (back) 1 → 2 → 3 → 5
That is eight bars in total. Bar 4 is often a fill that leads back, and bar 5 often leads into the next section. The most common mistake is playing bar 4 again the second time.
Example 2 — Bar Repeats With Numbers
Drum charts are full of bar-repeat signs because grooves go on for a long time. Small numbers (2, 3, 4 …) above the signs tell you which bar you are on.
Chart: | groove | % | % | % | fill ||
(1) (2) (3) (4)
Play order: groove for 4 bars (1 written + 3 repeats) → fill
For long runs of repeats, count the bars out loud: “one, two, three, four.” Many songs move in eight-bar blocks, so get used to checking that the fill lands in bar 8. You can practice counting bars in Song Structure for Drummers — What to Play in the Verse, Chorus and Bridge (Notation and Audio).
Example 3 — D.C. al Fine
Chart: | A1 | A2 | A3 | A4 Fine || B1 | B2 | B3 | B4 D.C. al Fine || Play order: A1–A4 → B1–B4 → (back to start) A1–A4 → end
The first time through A, ignore the Fine and keep going. Fine only becomes the ending after the D.C. sends you back.
Example 4 — D.S. al Coda (the Most Common Pop Layout)
Pop and rock charts often play the intro once, repeat the verse and chorus, then finish with an outro — exactly what D.S. al Coda is for.
Chart: | Intro | 𝄋 Verse | Chorus To Coda 𝄌 | Bridge D.S. al Coda || 𝄌 Outro ||
Play order: Intro → Verse → Chorus → Bridge
→ (back to 𝄋) Verse → Chorus → (jump at To Coda) 𝄌 Outro → end
The first time through the chorus, ignore To Coda and go on to the bridge. Like Fine, To Coda only applies after the D.S. sends you back. So the intro is played once and the verse and chorus twice.
Three Rules for When You Get Confused
- Fine and To Coda only count after you jump back. Ignore them the first time.
- After a jump back, repeats are usually not taken again. If a repeat sits inside the section you go back to, the common convention is to play it once and move on. If the chart says to take the repeats, or your band agrees to, do that.
- The coda is usually set apart at the very end. Charts leave a gap or a double bar line after the D.S. bar and write the coda below, so check whether the last line is the coda before you start.
With a new chart, pencil numbers ①②③ over the bars in playing order, or write the order across the top: “Intro → Verse → Chorus → Bridge → Verse → Chorus → Coda.” When the whole band is reading the same line, mistakes drop a lot.
How to Practice Reading Repeat Signs
- Listen to a song you like and write its sections in order (intro, verse, chorus, bridge, outro).
- Rewrite that order using D.S. al Coda, like Example 4. Count how much shorter it got.
- Follow the shortened chart from start to finish while listening, pointing to where you are.
- Finally, play along on the drums while following the same order.
Practice with DrumMate
The DrumMate library has drum charts for more than 1,000 songs, together with the original recordings — a good way to learn a real song’s section order by ear and by eye. Connect an electronic drum kit and every bar is scored for timing and accuracy.